両方の PSU が ATTONav で停止していると報告されます

• ファブリック接続MetroCluster
• ATTO FB7500N

ファブリック接続 MetroCluster 構成内の ATTO FB7500N デバイスの 1 つが、両方の PSU が ATTONav HTTP インターフェイスで停止していると報告します。

 

 

CLI インターフェイスでも同じことが報告されます。

 

Device Status      = Good
Unsaved Changes     = None
Device         = "FibreBridge 7500N"
Serial Number      = FB7500NXXXXXX
Device Version     = 3.20
Board Revision     = 7
Build Number      = 001U
Build Type       = Release
Build Date       = "Aug 17 2020" 13:17:43
Flash Revision     = 0.02  
Firmware Version    = 3.20
BCE Version (FPGA 1)  = 15
BAU Version (FPGA 2)  = 33
User-defined name    = "ATTO_xyz        "
World Wide Name     = 00 00 00 00 00 00 00 00 
MB of RAM Installed   = 512
FC1 Node Name      = 00 00 00 00 00 00 00 00 
FC1 Port Name      = 00 00 00 00 00 00 00 00 
FC1 Data Rate      = 16Gb
FC1 Connection Mode   = ptp
FC1 FW Revision     = 10.6.103.8
FC2 Node Name      = 00 00 00 00 00 00 00 00
FC2 Port Name      = 00 00 00 00 00 00 00 00 
FC2 Data Rate      = 16Gb
FC2 Connection Mode   = ptp
FC2 FW Revision     = 10.6.103.8
SAS FW Revision     = 3.09.52
MP1 IP Address     = 0.0.0.0
MP1 IP Subnet Mask   = 0.0.0.0
MP1 IP Gateway     = 0.0.0.0
MP1 IP DHCP       = disabled
MP1 MAC Address     = 00-00-00-00-00-00
MP2 IP Address     = 0.0.0.0
MP2 IP Subnet Mask   = 0.0.0.0
MP2 IP Gateway     = 0.0.0.0
MP2 IP DHCP       = enabled
MP2 MAC Address     = 00-00-00-00-00-00
SNMP          = enabled
SNMP Community String = n/a
PS A Status       = Down
PS B Status       = Down
Active Configuration  = NetApp