メインコンテンツまでスキップ

D_Portテストが開始されていない状態です

Views:
25
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

環境

  • Brocadeスイッチ
  • ファブリックMetroCluster

問題

D_Portテストを実行しているときは、「Not started」状態のままになります。

例:

S1Switch01:admin> portdporttest --show 0
D-Port Information:
===================
Port:               0
Remote WWNN:           10:00:d8:1f:cc:10:86:2a
Remote port index:        0
Mode:               Automatic
No. of test frames:        1 Million
Test frame size:         1024 Bytes
Pattern:             jCRPAT
FEC (enabled/option/active):   Yes/No/No
CR (enabled/option/active):    Yes/No/No
Start time:            Mon Dec  7 13:26:16 2020
End time:             -------------------
Status:             NOT STARTED
================================================================================
Test           Start time    Result      EST(HH:MM:SS)   Comments
================================================================================
Electrical loopback    --------     NOT STARTED   --------     ----------
Optical loopback     --------     NOT STARTED   --------     ----------
Link traffic test     --------     NOT STARTED   --------     ----------
================================================================================
Roundtrip link latency:      unknown
Egress power:           Tx: -2.0 dBm, Rx: Not Avail.
Ingress power:          Rx: -4.8 dBm, Tx: Not Avail.

S2Switch01:admin> portdporttest --show 0
D-Port Information:
===================
Port:               0
Remote WWNN:           10:00:d8:1f:cc:10:86:2a
Remote port index:        0
Mode:               Automatic
No. of test frames:        1 Million
Test frame size:         1024 Bytes
Pattern:             jCRPAT
FEC (enabled/option/active):   Yes/No/No
CR (enabled/option/active):    Yes/No/No
Start time:            Mon Dec  7 13:26:31 2020
End time:             -------------------
Status:             NOT STARTED
================================================================================
Test           Start time    Result      EST(HH:MM:SS)   Comments
================================================================================
Electrical loopback    --------     NOT STARTED   --------     ----------
Optical loopback     --------     NOT STARTED   --------     ----------
Link traffic test     --------     NOT STARTED   --------     ----------
================================================================================
Roundtrip link latency:      unknown
Egress power:           Tx: -2.5 dBm, Rx: Not Avail.
Ingress power:          Rx: -3.5 dBm, Tx: Not Avail.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.