メインコンテンツまでスキップ

MetroCluster Config Advisor のゾーニング設定エラー

Views:
25
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

のしんだ

に適用されます

  • MetroCluster
  • Config Advisor

問題

ConfigAdvisor は、次のいずれかのメッセージを報告します。

  • Switch Fabric does not contain the correct number of switches, one switch may be down, fabric is segmented, or too many switches seen
  • No FCVI zone in fabric for switches found
  • FCVI port is part of more than one zone
  • FCVI zones in fabric for switches does not contain all FCVI ports of the DrGroup
  • FCVI zone in fabric for switches has one or more FCVI ports represented with their WWN
  • FCVI zone in fabric for switches are not a QoS zone with priority 'high'.
  • FCVI zone in fabric for switches does contain one or more non-FCVI ports.
  • Storage zone in fabric for switches contain one or more ports that are not a Storage HBA and not a FibreBridge.
  • Storage zone in fabric for switches are incorrect and contain too many storage initiator ports.
  • Storage zone in fabric for switches are incorrect and contain not enough storage initiator ports.
  • Storage zone in fabric for switches are incorrect and contain too many FibreBridge ports
  • Storage zone in fabric for switches have one or more ports represented with their WWN.
  • No Storage zone in fabric for switches found.
  • Storage zoning configuration on Switch is not expected Storage zone.
  • Traffic Isolation (TI) zone configuration found on switch, TI is not supported in this configuration.
  • Storage zone in fabric for switches contain or more ports that are not a Storage initiator and not a target array port.
  • Storage zone in fabric for switches are and contain too many target array ports
  • Defined zone and effective zone do not match.
  • Zone is defined and not member of a configuration
  • Zone is defined but not active

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device