メインコンテンツまでスキップ

RCFの適用後にCiscoスイッチの実行コンフィギュレーションに「CDP enable」が表示されないのはなぜですか。

Views:
5
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
network
Last Updated:

環境

  • IP 経由の MetroCluster
  • クラスタ スイッチ
  • Cisco
  • リファレンス構成ファイル(RCF)
  • Cisco Discovery Protocol(CDP)

回答

  • cdp enable この設定は、グローバルに無効になっている場合にのみ、running-configに表示されます
  • CDP設定を確認するには show cdp neighbors 、代わりにコマンドを使用します

site-a-sw2# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater,
                  V - VoIP-Phone, D - Remotely-Managed-Device, s - Supports-STP-Dispute
Device-ID         Local Intrfce  Hldtme Capability  Platform      Port ID
cbc-mgmt-sw-r01     mgmt0          138    S I       WS-C2960-24TT Fas0/22
cluster-a-01        Eth1/3         176    H         AFF-A800      e1a
cluster-a-02        Eth1/4         174    H        AFF-A800      e1a

追加情報

Nexus OSの最新バージョンについて はCiscoのWebサイトを参照してください

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.