メインコンテンツまでスキップ

MetroCluster - 「アグリゲートの削除」が完了しませんでした。場所情報を削除できませんでした

Views:
8
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

に適用されます

ONTAP 、 MetroCluster の略

問題

MCC システムのノード上で 1 つのデータアグリゲートのみを削除すると、アグリゲート名シルが「 unknown 」の状態ののの出力に表示されます。aggr show

MCC2::*> aggr show
Aggregate    Size   Available  Used%  State   #Vols Nodes  RAID  Status
---------   --------  ---------  -----  ------  ----- ------- -------------
aggr0_MCC2_01 1.40TB  69.36GB   95%   online   1   MCC2-01 raid_dp, mirrored,normal
aggr0_MCC2_02 1.40TB  69.36GB   95% online    1   MCC2-02 raid_dp, mirrored,normal 
aggr1_MCC2 - - -unknown - MCC2-01 -
3 entries were displayed.
 
コマンドaggr remove-stale-recordは機能しません 
 
MCC2::*> aggr remove-stale-record -aggregate aggr1_MCC2 -nodename MCC2-01
Error: command failed: The specified aggregate "aggr1_MCC2" does not correspond to a stale aggregate record. Use the "storage aggregate delete" command to delete this aggregate.
 
EMS で以下のエラーメッセージが表示される
 
[MCC2-02: mgwd: mgmtgwd.jobmgr.jobcomplete.failure:info]: Job "Aggr Delete" [id 132] (Delete aggr1_MCC2) completed unsuccessfully: Failed to remove the location information of aggregate aggr1_MCC2 from VLDB due to The MetroCluster or Vserver DR Configuration Replication Service is recovering. Issue the "metrocluster check config-replication show -instance" command or the "snapmirror config-replication status show" command and follow its guidance. If there is no guidance, wait a few minutes and then try the command again.. . Retry later. (1).

 

CUSTOMER EXCLUSIVE CONTENT

Registered NetApp customers get unlimited access to our dynamic Knowledge Base.

New authoritative content is published and updated each day by our team of experts.

Current Customer or Partner?

Sign In for unlimited access

New to NetApp?

Learn more about our award-winning Support

 

 

  • この記事は役に立ちましたか?