メインコンテンツまでスキップ

スイッチポート「 x 」が正常な状態でないか、スイッチポート「 x 」でエラーが発生しています

Views:
140
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

環境

  • Fibre Channel Protocol ( FCP ;ファイバチャネルプロトコル)
  • SAN
  • Brocade
  • Cisco

 

問題

Brocade / Cisco のスイッチポートが正常な状態でないか、スイッチポートに複数のエラーがあります。

  • スイッチログ( Brocade ):
 2020/03/10-10:20:06, [C4-1010], 13033, SLOT X CHASSIS, CRITICAL, Brocade_XX-X, X,X: Above normal hardware errors were observed: fault1:0x64, fault2:0x64 thresh2:0xb0000064.2019/06/01-08:39:16, [C3-1014], 74, CHASSIS, WARNING, xxxxx, Link Reset on Port Sx,Px(x) vc_no=0 crd(s)lost=x auto trigge 
  • スイッチログ( Cisco ):

2020 Aug 25 04:26:00 %PORT-5-IF_DOWN_NOS_RCVD: %$VSAN 451%$ Interface fc1/13 is down (NOS received)

  • Low TX または RX Power 値:
 
RX Power:    -40.0   dBm (0.1  uW)   31.6   uW  1258.9 uW  31.6   uW   794.0  uW
TX Power:    -2.2    dBm (600.1 uW)  126.0  uW  1258.9 uW  251.0  uW   794.0  uW
 
  • パフォーマンスの問題:
 2020/05/19-20:08:21, [AN-1010], 687622, FID 128, WARNING, XXXX, Severe latency bottleneck detected at slot 0 port 
 
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.