MetroCluster - 「アグリゲートの削除」が完了しませんでした。場所情報を削除できませんでした

最後の更新
PDFとして保存

Views:: 31

Visibility:: Public

Votes:: 0

Category:: metrocluster

Specialty:: metrocluster<a>MDV</a><a>2008525051</a>

Last Updated:

環境

ONTAP
MetroCluster

問題

MCC システムのノード上aggr showで 1 つのデータアグリゲートのみを削除すると、アグリゲート名シルが「 unknown 」の状態のとして出力に表示されます。

MCC2::*> aggr show

Aggregate Size Available Used% State #Vols Nodes RAID Status

--------- -------- --------- ----- ------ ----- ------- -------------

aggr0_MCC2_01 1.40TB 69.36GB 95% online 1 MCC2-01 raid_dp, mirrored,normal

aggr0_MCC2_02 1.40TB 69.36GB 95% online 1 MCC2-02 raid_dp, mirrored,normal

aggr1_MCC2 - - -unknown - MCC2-01 -

3 entries were displayed.

コマンドaggr remove-stale-recordは機能しません

MCC2::*> aggr remove-stale-record -aggregate aggr1_MCC2 -nodename MCC2-01

Error: command failed: The specified aggregate "aggr1_MCC2" does not correspond to a stale aggregate record. Use the "storage aggregate delete" command to delete this aggregate.

EMS のエラーメッセージ：

[MCC2-02: mgwd: mgmtgwd.jobmgr.jobcomplete.failure:info]: Job "Aggr Delete" [id 132] (Delete aggr1_MCC2) completed unsuccessfully: Failed to remove the location information of aggregate aggr1_MCC2 from VLDB due to The MetroCluster or Vserver DR Configuration Replication Service is recovering. Issue the "metrocluster check config-replication show -instance" command or the "snapmirror config-replication status show" command and follow its guidance. If there is no guidance, wait a few minutes and then try the command again.. . Retry later. (1).