SP情報が正しく表示されない
環境
FAS2650
問題
- SPの健常性が低下していると表示されます。
Node03::> system health subsystem showSubsystem Health----------------- ------------------SAS-connect okEnvironment okMemory okService-Processor degradedNode03::> system health alert showNode: Node03-02Resource: SP ConfigSeverity: MajorIndication Time: Tue Jan 19 09:21:38 2021Suppress: falseAcknowledge: falseProbable Cause: Service Processor in node Node03-02 has no network connectivity.The cable between the Wrench port on the controller and the ethernet switch is disconnected.Possible Effect: You might not be able to use the Service Processor to remotely access, monitor, and troubleshoot your storage system.Corrective Actions: 1. Check the connection between the Wrench port and the ethernet switch. 2. If the cable is properly connected, ensure that the Service Processor's ethernet interface is configured properly by executing the command "system service-processor network show". 3. Check for network cable related issues. 4. Contact the technical support if the alert persists.- ノード Node03-02の 情報を表示できません。
Node03::> system service-processor showIP FirmwareNode Type Status Configured Version IP Address------------- ---- ----------- ------------ --------- -------------------------Node03-01 SP online true 5.1P1 XXX.XXX.XXX.XXXError: show failed: RPC: Unable to sendNode03::> system service-processor network showAddressNode Status Family Link State IP Address------------- -------------- --------- ----------- ------------------------Node03-01 online IPv4 up XXX.XXX.XXX.XXXDHCP: noneMAC Address: XX:XX:XX:XX:XX:XXNetwork Gateway: XXX.XXX.XXX.XXXNetwork Mask (IPv4 only): XXX.XXX.XXX.XXXPrefix Length (IPv6 only): -IPv6 RA Enabled: -Subnet Name: -SP Network Setup Status: succeeded......Error: show failed: RPC: Unable to send2 entries were displayed.- しかし、 sysconfig -a では Attention LED は消灯しており、SP のステータスはオンラインになっています。
Node03::> node run -node * sysconfig -aNode: Node03-02NetApp Release 9.1P11: Thu Dec 21 02:32:26 PST 2017......Service Processor Status: OnlineFirmware Version: 5.1P1Mgmt MAC Address: XX:XX:XX:XX:XX:XXEthernet Link: up, full duplex, auto-neg completeUsing DHCP: noIPv4 configuration:IP Address: XXX.XXX.XXX.XXXNetmask: XXX.XXX.XXX.XXXGateway: XXX.XXX.XXX.XXXIPv6 configuration: Disabled- SPを再起動しても問題は解決できません。