メインコンテンツまでスキップ

クラスタスイッチの健常性監視をSNMPv3を使用するように変更できない

Views:
4
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw<a>2009979342</a>
Last Updated:

環境

  • ONTAP 9
  • Cisco 9336クラスタスイッチ
  • クラスタ スイッチ

問題

  • SNMPv3を使用するようにスイッチの監視を変更できません:

netapp01::*> system switch ethernet modify -device netapp-1.netapp.com(xxxxxx) -snmp-version SNMPv3 -community-or-username SNMPv3User

Warning: Settings updated, but the SNMPv3 validation request timed out. Verify that the "-community-or-username" parameter is valid (i.e., the SNMPv3 user exists in ONTAP and on the remote switch). If the
"-community-or-username" parameter is valid, verify that the SNMPv3 user's credentials are the same both in ONTAP as well as in the remote switch. If a custom engine-id was provided for the SNMPv3 user,
ensure it is the same as that of the remote switch.

  • スイッチがSNMPv2を使用して正常に監視される
  • SNMPv3を監視用に設定する方法については、次のドキュメントを参照してください。 SNMPv3を設定する

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • この記事は役に立ちましたか?