メインコンテンツまでスキップ

イーサネット RLM インターフェイスと e0M インターフェイスが停止し続ける

Views:
84
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
network
Last Updated:

のしんだ

環境

Data ONTAP 7 以前

問題

イーサネット RLM/e0M インターフェイスがダウンし続けています。同じ RLM ポートと e0M ポートからの MAC アドレスは 2 つあります。セキュリティの観点からは、 IOS で認識されている MAC アドレス違反があるため、インターフェイスが強制的にシャットダウンされます。

Fri Dec 11 20:27:07 GMT [3140M: netif.linkUp:info]: Ethernet RLM/e0M: Link up.
Fri Dec 11 20:27:10 GMT [3140M: netif.linkDown:info]: Ethernet RLM/e0M: Link down, check cable.
Fri Dec 11 20:27:53 GMT [3140M: rlm.driver.mailhost:warning]: RLM setup could not access the mailhost specified in 'options autosupport.mailhost'.
Fri Dec 11 20:27:54 GMT [3140M: rlm.driver.network.failure:warning]: The network configuration of the Remote LAN Module (RLM) failed due to cable or network errors.
Fri Dec 11 20:28:00 GMT [3140M: rlm.driver.timeout:warning]: The software driver for the Remote LAN Module (RLM) detected a problem: Cannot send takeover configuration..
Fri Dec 11 20:28:00 GMT [3140M: cf.hwassist.notifyCfgFailed:CRITICAL]: Failed to notify hardware-assist configuration to hardware module (RLM): UNKNOWN(7)
Fri Dec 11 20:28:00 GMT [3140M: rlm.driver.timeout:warning]: The software driver for the Remote LAN Module (RLM) detected a problem: Cannot send takeover configuration..

> rlm status
  Remote LAN Module           Status: Online
    Part Number:        110-00057
    Revision:           D0
    Serial Number:      451541
    Firmware Version:   4.0
    Mgmt MAC Address:   00:A0:98:0B:E8:3D
   Ethernet Link:      up, 100Mb, full duplex, auto-neg complete
    Using DHCP:         no
  IPv4 configuration:
    IP Address:         unknown
    Netmask:            unknown
    Gateway:            unknown
  IPv6 configuration:         Disabled

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.